CoilCell

Discover our 1.3mm thin compact PCB coils with an integrated driver! Connect directly to your favorite microcontroller to control magnetic strength and polarity, adding motion to magnets. Easily add more coils with its solderable pads for even more fun!

€4,99

| /

Magnetically Compact

Constructed from a multi-layered PCB, CoilCell is an ultra-thin planar coil with an integrated driver, making it compact while simplifying control of magnetic polarity and strength

Start with Examples

Install the CoilCell Arduino Library to quickly get started!

The CoilCell Library is available for download on both Github and the Arduino Library manager. Basic functions work on all Arduino boards + optimized PWM functions for CodeCell & other ESP32 devices

Download Library

Things You Can Build

Bouncing Magnets
Keep it fixed and add lightweight magnets on top to make them bounce

Flip
Pivot a magnet and watch it flip, just like a mechanical Flip-Dot pixel

Vibrate
Hide magnets inside lightweight objects ~ Find its resonance to Shake Things Up!

Specifications

Electrical:

Resistance: 24Ω ± 6
Inductance: 29.8uH ± 1
Maximum Power: 1W
Maximum Voltage: 5V
Operating Temperature: 70°C
Peek Magnetic Field Strength: 2.3mT @ 5V

Mechanical:

Dimensions: 18.5x18.5mm
Thickness: 1.3mm
Weight: 0.5 grams (1-Cell)
Screws: M1.2
Connector Pitch: 2.54mm

3D Model

Add More

Reduce wiring by soldering neighboring cells together! Utilize the side connectors to share power and input signals.

Each CoilCell input can be customized uniquely with separate wires, or wired with the same input signal. Pre-connected 1x5 CoilCells are also available.

Notes:

The CoilCell is a planar PCB coil with an on-board DRV8837 h-bridge chip which can control the direction and strength of the current flowing through the coil. This allows the CoilCell to be driven magnetic north (IN1 = PWM, IN2 = GND), south (IN1 = GND, IN2 = PWM) or OFF (IN1 = GND, IN2 = GND)
The DRV8837 chip has Overcurrent Protection, Undervoltage Lockout & Thermal Shutdown. Caution must be taken not to reverse its supply rails.
This electronics kit is ROHS Compliant & follows IPC-A-600 II standard.
The force produced by a CoilCell depends on the mechanical elements of your project, as well as the weight and strength of your magnet.
The box will include the CoilCell, a set of four M1.2 screws and any optional magnets.
Any soldered wires must be non-magnetic to prevent magnets from attaching to them.
Please note that the CoilCell is intended to be used as a DIY maker kit. For commercial purposes, please get in touch.

Contact

CoilCell

Magnetically Compact

Start with Examples

Things You Can Build

Specifications

Add More

You may also like

Follow

Insert Image from Link